I have lot of Sonoff devices in use and the Scene funcion is great!
I found that when I start to create new Scene (Add Scene) and try to add new devices (Execute Devices) , then I can see (add) only 19 sonoff devices. However I have more sonoff devices added to my ewelink. I can control them freely one by one, but I cant add them to Scene. Is there some kind of limitation in eWeLink software?
True, I plugged in a sensor and it shows up, but only as trigger for other switches (when temperature is lower than...) not in the execute part of the scene
My TH16's only show up when they have a temperature sensor plugged in.
Fwiw since the last phone app update (Yesterday) the list of both devices you can employ to trigger an action and the list of devices to control are fully populated ;)
However devices shared from another paired phone still do not show up within scenes ..
the same here, but I have only 4 devices, one of them TH16, others are Sonoff Basic WiFi Wireless Switch. Only TH16 is not available on scene mode as execute device.
I have a similar problem. im using V3.0 of the android app and have about 29 sonoff devices linked/paired.
Mainly sonoff basic switches but also including 2 x BN-SZ01, 2 x dual, 1 x pow, 1 x th16, 2 x SC, and 1 x rf bridge with 4 x 433mhz PIR2 sensors paired.
All devices with an available firmware upgrade have had said upgrade applied successfully.
when trying to create a scene the devices available to trigger action is very short, and comprises of a single SC and 2 sonoff basic switches??
the app on its 'all devices' list indicates the status of all devices correctly and logs all pir alarms, and both SC devices display readings reflecting current temps etc..
I would rather not have to re-pair all the devices again as some are especially tricky to get into pair mode (BN-SZ01) and quite a lot are hidden away inside light fittings and wall sockets, but i fear that will be the simple solution.
please advise if an alternative solution exists,
Seems that issue is not the number of devices .... I deleted one device from my list and now I can operate with 18 sonoff devices from Scene point of view. When I add now new device - I m not able to add this device to existing Scene. I deleted all scenes and tried to start from the beginning. Result: I have 21 devices on my device list, but I can use only 18 of them in Scenes. This is a bit confusing ...
Does anyone have seen the same problem?